Select Page

9MM Ruger American Safety Bulletin

Ruger has found that on certain 9mm American pistols, premature wear can cause a crack to develop near the ejection port of the slide. While this doesn’t generally occur below round counts near 10,000, it is easily inspected for and the retrofit to repair the...

Kel-Tec Sub-2000 Safety Recall Notice

Kel-Tec has found that a number of Sub-2000’s manufactured in 2017 had received faulty heat treatment on the steel tubes used for the barrel, and run a risk of rupturing during fire. To identify if your firearm is affected, please check the serial number on...

Smith & Wesson M&P380 Shield EZ Consumer Advisory

Smith & Wesson has found that the version of this pistol with the manual thumb safety can have that safety unintentionally engaged by shooting recoil. This occurs with ammunition that produces a high felt recoil, and will not allow the next round to be fired until...

Sig Sauer Rifle Recall

SIG SAUER, Inc. has determined that a limited number of rifles in the SIG716 DMR®, SIG516® Carbon Fiber and SIGM400® Predator models were built with a two-stage SIG SAUER trigger that may have an improperly heat-treated hammer. Over time this could result in a trigger...